GMP J2 Wire/Cable Lasher

The Model J2 Cable Lasher is used to lash a single aerial cable or numerous cables to a supporting strand or to an existing lashed cable with stainless steel lashing wire.

• Will lash any single or multiple aerial cables up to 3 in. (76mm) diameter across on any suspension strand from 1/4 in. (6mm) to 7/16 in. (11mm).
• Consists of a rotating drum supported on a carriage that provides the mounting for a driving mechanism, cable Lifters, cable and strand rollers
• Each of the two recessed magazines will hold a 1200 ft. coil of .045 in. (365m of 1.1mm wire) lashing wire. The lashing wire is fully recessed and covered by a gate.
• Features a fast setup procedure, quick coil loading, and automatic drum lock for easy span transfers and smooth forward travel
• J2 Lashers make overLashing easy. Just push down on the strand roller knob, rotate it a quarter turn and you can lash additional cables together on previously lashed cable
• Positive internal gear to gear mechanism has no chains or belts to stretch, slip or break
• Constructed with heat-treated, plated Steel, stainless Steel, brass and aluminum components. Contains sealed and oiless bearings to minimize maintenance and assure durability.
• Pre-drilled and tapped at the factory for Mounting of the Lasher Guard or “halo”. For use when Lashing in overgrown areas.
• The J2 and every GMP lasher is fully serviceable to “good-as-new” specifications at our factory and at factory-trained service locations around the globe.
• The lasher is furnished with a rugged lightweight storage chest with corrosion resistant hardware, recessed latches and a moisture-proof, tongue-in-groove design for maximum protection when not in use
• Supplied with a 6 ft. bridle rope assembly and snap hooks, and an information and operation manual
  

SKU: 86070